Canon CR-50 Manual de instrucciones

Please read this manual before operating this scanner.Instructions

10 Keep the area around the power outlet clear of all obstacles so you can disconnect the power cord easily at all times. Never spill water or volat

11Power Supply• Connect only to a power outlet of the rated voltage and power supply frequency (either 120V, 60 Hz or 220-240V, 50/60 Hz, depending on

12Introduction to the CR-50/80This chapter describes the features of the CR-50/80 scanner, what comes packaged in the box, and the names and functions

13Make sure that you have everything shown below. Check every item you have removed from the box. If any items are missing, contact your local authori

14This section describes the names and functions of each part. Before you connect the CR-50/80, familiarize yourself with its parts and their function

15Ink CartridgeThe ink cartridge is not included, and must be purchased separately. (See “About the Ink Cartridge,” on p. 24.)Print Position Adjustmen

16Rear ViewCAUTIONTo avoid overheating and causing a fire, never block the air vents on the back of the scanner.Connectors/Power SwitchUnits: millimet

17Preparation Before UseThis chapter describes how to prepare the scanner to scan documents.Perform the following steps to set up the CR-50/80. Refer

18The following computer system requirements are recommended for using the CR-50/80.Operating Systems:• Microsoft Windows XP (32bit) SP3 or later• Mic

19The following software application is provided on the setup disc that is packaged with the scanner. Make sure to open and read the Readme.txt file o

2Connecting the Scanner to a ComputerConnect the CR-50/80 to a computer as follows. Make sure to install the software before connecting the scanner to

20D Click [Accessories], and then click [Run].E Enter “D:\SU80\setup.exe” in the [Open] fields, and then click [OK].Installation starts.F Follow the i

21The only way to connect the scanner to your computer is with a USB cable.IMPORTANT• Be sure to use the USB cable bundled with the scanner or a Hi-Sp

22Connecting the Power CordConnect the power cord.Make sure to use only the power cord provided with the scanner.WARNINGWhen connecting the power cord

23IMPORTANT• When you turn ON the power, the power LED lights and remains lit.• If the scanner does not work, there is a problem with the scanner. Tur

24This section describes how to prepare the ink cartridge so that you can use the imprinter to print text on scanned documents.About the Ink Cartridge

25C Remove the ink cartridge from its bag.IMPORTANTDo not touch the ink cartridge contacts. This can cause a bad electrical contact and reduced print

26NOTEDo not use more than one cartridge by rotation. If you do so, applications cannot check the ink level precisely.F Push down the ink cartridge un

27H Carefully replace the Imprinter Cover.I Gently close the Maintenance Cover until it clicks into place.

28SoftwareThis chapter describes how to use the Scanning Utility.This section describes how to start up the Scanning Utility so that you can use the s

29NOTEThe basic operation of the Scanning Utility is noted in the Scanning Utility help file. On the [Help] menu, click [Help] to view the explanation

3READ CAREFULLY BEFORE OPENING THE SEALED DISK PACKAGECANON SOFTWARE LICENSE AGREEMENTIMPORTANT-READ THIS AGREEMENT BEFORE OPENING THE SEALED DISK PAC

30G When scanning is finished, click [Exit] on the [File] menu to quit the Scanning Utility.This section describes how to uninstall the Scanning Utili

31B Click [Programs], and then click [Programs and Features].NOTEDepending on the status of your computer, the following screen may be displayed. In t

32NOTEWhen the [User Account Control] dialog box appears, click [Continue].IMPORTANTIf you uninstall the “Scanning Utility for CR-50/80” you also need

33Document Feeding and ScanningThis chapter describes precautions regarding documents that can be handled on this scanner and scanning operations.This

34NOTE• Note that mixing documents of different thickness may cause a malfunction during feeding.• Curled, wrinkled, or folded documents may cause an

35Placing DocumentsNote the following points when placing documents on the scanner.• Place the front of the document toward you.• A maximum of 50 docu

36Scan ProcedureA Pull out the document feed tray.B Carefully align the edges of the document.C Load the documents with their front sides facing right

37F Scanning starts.NOTEWhen printing with the imprinter, ink may get on the leading edge of the document because the documents are ejected onto the p

38NOTEFor instructions on using the scanning utility, see “How to Use the Scanning Utility,” on p. 28. You can also refer to the scanning utility help

39NOTEIf the sheets do not feed properly (they double-feed or no sheets are fed), see “Adjusting the Separation Roller Gap,” on p. 52 to adjust for pa

4FCC REGULATIONS (For 120V model)Check Reader, Model M111101/M111102This device complies with Part 15 of the FCC Rules. Operation is subject to the fo

40TroubleshootingThis chapter describes the problems that might occur in the CR-50/80, and how to remedy them.The following causes and remedies descri

41B While lowering the down the OPEN lever, open the reading unit.C Remove the paper that has jammed.If the paper is jammed at the pickup area: Pull t

42E Gently close the Maintenance Cover until it clicks into place.Check the following conditions, and take the appropriate action.The power switch is

43If the document is not fed properly or the detection functions do not work properly, remedy the problem by checking the following conditions.Feeding

44If there is a problem with the scanned image (the image is not sharp or stripes appear), one of the following conditions may be a probable cause. Ch

45MaintenanceThis chapter describes how to clean and maintain the scanner.To ensure high-quality image scanning, regularly clean your CR-50/80 as desc

46B While lowering the open lever, open the reading unit.WARNINGDo not use flammable liquids to clean the scanner, including alcohol, benzene, or pain

47D Use cotton swabs to clean the entire scanning glass. There are two scanning glass areas, one on each side. Use a cotton swab to wipe dirt from the

48Cleaning the Magnetic HeadsIf the magnetic heads are dirty, then MICR characters cannot be scanned correctly. Periodically, clean the magnetic heads

49Cleaning the Ink Jet NozzlesInk that collects around the ink jet nozzles may stain your documents or cause the text to appear as scratched. Clean th

5Trademarks• Canon and the Canon logo are registered trademarks, of Canon Inc. in the United States and may also be trademarks or registered trademark

50F Carefully replace the Imprinter Cover.G Gently close the Maintenance Cover until it clicks into place.Make the following adjustments to maintain s

51A Hook your finger around the open lever and open the Maintenance Cover.B Remove the Imprinter Cover.C Squeeze in both sides of the print position a

52E Set the ink cartridge.For more information, see “Setting the Ink Cartridge and Adjusting the Print Position,” on p. 24.F Carefully replace the Imp

53B Pull out the document feed tray.C Load two checks or check-stock paper together.D Slide the two sheets through between the feeding roller and the

54F Adjust the gap between the feeding roller and the separation roller to optimum width.While one sheet remains in place between the rollers, continu

55Scanner SpecificationsAC Adapter Specifications Use the recommended operating environment for the ink cartridge when using the imprinter. You can

56IndexAAC Adapter Specifications ... 55Adjusting the Print Position...

57PPaper Thickness Adjustment Dial... 14Power Connector ...

CANON ELECTRONICS INC.1248, SHIMOKAGEMORI, CHICHIBU-SHI, SAITAMA 369-1892, JAPANCANON U.S.A. INC.ONE CANON PLAZA, LAKE SUCCESS, NY 11042, U.S.A.CANON

6INTRODUCTIONThank you for purchasing the Canon Check Reader CR-50/80.Please read this manual thoroughly before using the machine in order to familiar

7Table of ContentsConnecting the Scanner to a Computer... 2INTRODUCTION ...

8Maintenance ...... 45Daily Cleaning...

9Important Safety InstructionsHandlingWARNING Never install and operate the scanner near flammable substances, such as alcohol, paint thinner, benzen