Canon PIXMA MX300 Manual de servicio

Busca en linea o descarga Manual de servicio para Multifuncionales Canon PIXMA MX300. Canon PIXMA MX300 Service manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 7
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
How to Default Printer Setting after Refill For Canon’s Printer
Method 1 (Quoted)
Here is how to reset MX330 Ink Cartridge (210 model) Counter in Win Vista System:
1. Refill cartridge and install back to printer.
2. Open Properties in "Printers" from "Start Bar"-"Settings" on left lower corner.
3. Open "Advance".
4. Uncheck "Enable advanced printing features".
5. Apply and close.
6. Hold "Stop" button on MX330 printer for 10-20 seconds. The "Run out of ink" message will disappear.
7. Open "Properties" in "Printers" again as in Step 2.
8. Check "Enable advance printing features" to reset counter.
9. Printer should work again with refilled ink cartridge. (Unquote)
Information extracted on 14 September 2010 from URL: http://forums.steves-digicams.com/photo-
inkjet/155728-canon-mx330-not-sure-how-reset-ink-cartridge-printer-meter-manual-refill.html
Method 2 (Quoted)
Tried refilling the cartridges PG210 & CL211 inside my Canon MX 320, it goes well for 2 refills,
however on the third time after I refilled, an error code 'U051' appeared on the little LED screen says
'Check ink U051 clo blk'. The printer worked the first two times by pushing down on the stop/reset
button for 5 seconds but not this time. I tried another pair of cartridges from another printer (MP240) which
have been refilled a few times and still working, the same problem showed up. Does this mean I have to
buy a pair of brand new OEM Canon cartridges after 2 refills on this particular model? I tried putting the
printer into service mode and tried the resetting counter method etc. and none help. Anyone any
suggestions?
Sorry to hear you’re not getting any help on here. So try this, buy a new set of canon cartridges and when
they run out put back in your current set which should work again. You need to rotate your cartridges and
not keep putting back in the same ones all the time. That way you will always have a spare set on hand..
Assuming that your printer (ip4600 series) is already installed on your PC.
Reset can be done once your printer is on Service Mode:
a. Switch Off the Printer
b. Hold the Resume Button
c. Switch On and Hold the Power Button
d. Release the Resume Button
e. Press the Resume Button Twice
f. Release the Power Button
By this time your printer is in service mode already. Run the Service Tool Program (Resetter) Select ASA
as the Region (for ASIA PACIFIC - depends on your location) (Unquote)
Information extracted on 14 September 2010 from URL: http://www.multiupload.com/D79Z6MF212
Method 3 (Quoted)
Someone post this for Canon mx 300 (its supposed to works for the mx328 too) :
1- Switch off the Canon MX300 and disconnect the power cable.
2- While press and hold the power button, Connect the power cable to electric socket.
Vista de pagina 0
1 2 3 4 5 6 7

Indice de contenidos

Pagina 1

How to Default Printer Setting after Refill – For Canon’s Printer Method 1 – (Quoted) Here is how to reset MX330 Ink Cartridge (210 model) Counter i

Pagina 2

3- While pressing the power button, press the “Cancel/Stop” button (red button). (press TWICE che “stop\cancel” button) 4- Now release the power but

Pagina 3

1. Turn off power. 2. Hold down Resume button and press Power button. 3. Keep holding down Power button and let the Resume button go. 4. Press Resume

Pagina 4

Now is a good time to take it outside and use dry canned air to blow out the paper dust in the back of the printer. Do -not-, repeat NOT use an air c

Pagina 5

After everything is dry, reassemble everything but the top of the case. Locate the lid detector switch, it is usually somewhere near the hinge of the

Pagina 6

Extremely Thorough Cleaning: Take the head out, remove the cartridges. If you've saved the orange seals, tape them onto the cartridges, if not th

Pagina 7

* Do not reattach the protective cap once you have removed it. Discard it according to the local laws and regulations regarding disposal of consum

Comentarios a estos manuales

Sin comentarios