Canon MF8450c Guía de inicio rápido descargar pdf (Pagina 35)

2 Set Up the Machine

The “Setup Guide” only supports IPv4.

By default, the IP address is automatically assigned to the

machine by the DHCP server.

1 Make sure the following screen is displayed on

the display. Use [

▼

], [

▲

] or (Scroll Wheel) to

select <Set or Check Now> or <Set or Check

Later>.

A: When you use the machine through the network, select

<Set or Check Now> then press [OK].

B: When you do not use the machine through the network,

Select <Set or Check Later>, then press [OK]. (Go to

“Finish ‘Setup Guide’,” on p. 35.)

The setting for IPv6 is not supported with the “Setup Guide.”

When you want to use the machine on the IPv6

environment, select <Set or Check Later> and set it up after

nishing the “Setup Guide.” See “Network Settings,” in the e-

Manual.

–

2 Make sure the following screen is displayed on

the display, then press [OK] to proceed to the

“Setup Guide.”

If the LAN cable is not connected to the machine, a screen

instructing you to connect the LAN cable will appear

before this screen.

If the machine dose not get the IP address 3 minutes after

you connect the LAN cable, check the IP address settings

and the network cable.

3 Make sure the following screen is displayed on

the display, then press [OK] to proceed to the

“Setup Guide.”

–

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 59 60

Sin comentarios

Canon MF8450c Guía de inicio rápido Pagina 35