Canon imagePROGRAF iPF8300 Guía básica descargar pdf (Pagina 21)

Loading Sheets in the Printer

You can adjust the strength of suction holding paper against the Platen when the Release Lever is up.

If it is difﬁ cult to load paper, press the ▲ or ▼ button on the Control Panel to adjust the strength. Set

suction stronger by pressing the ▲ button or weaker with the ▼ button. Three settings are available.

•

Load a sheet so that it is parallel to the Paper Alignment Line at right (c). Loading paper askew will

cause an error.

•

For details on types of paper to select, see the Paper Reference Guide .•

Warped paper may rub against the Printhead . Straighten paper if it is warped before loading it.•

Sheets are held in place by suction through holes on the Platen . Although the suction may produce a

noise when paper is loaded in some positions, it does not indicate a problem. If the noise is distracting,

try moving the paper over slightly to the left or right (up to 1 mm [0.039 in]) while keeping it parallel to

the Paper Alignment Line .

•

The suction remains on for about 30 seconds during loading. If you cannot ﬁ nish loading a sheet during

this time, pull the sheet away and reinsert it to start the suction again.

•

However, even if you increase the suction, it may not be sufﬁ cient to hold some types of paper against

the Platen well. In this case, use your hand to load the paper.

(→

, Types of Manuals)

When using the Output Stacker , if you will print on large, stiff sheets, we recommend adjusting the

Output Stacker into the lowest position to prevent printed sheets from being bent.

•

(→"Using the Output Stacker," User Manual)

With a sheet lengthwise and printing-side up, insert it

between the Platen (a) and the Paper Retainer (b). Align

the edges of the sheet as follows.

Lower the Release Lever and close the Top Cover .

When inserted, sheets are automatically held by suction

against the Platen .

Align the sheet with the Paper Alignment Line (c) at

right.

Align the inserted edge of the sheet with the leading

edge of the Paper Alignment Line (d), as shown.

If a print job was received•

A menu for selection of the type of paper is automatically

shown on the Display Screen .

Pressing the OK button will advance the paper, and then

printing will begin.

If no print job was received•

Press ▲ or ▼ to select the type of paper, and then press

the OK button.

The printer now starts feeding the paper.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Comentarios a estos manuales

Sin comentarios

Canon imagePROGRAF iPF8300 Guía básica Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Canon imagePROGRAF iPF8300