Canon 9080C - DR - Document Scanner Manual de instrucciones descargar pdf (Pagina 25)

● The SCSI ID default is set to 2.

● Assign SCSI ID numbers ranging from 0 to 7 for each SCSI device. Do not select 7

as this is normally assigned to the SCSI controller. If a SCSI hard disk is mounted, do

not use 0 and 1. Normally 0 and 1 are assigned for hard disks.

Set the terminator on the last SCSI device on a daisy chain to ON.

<When only the scanner is connected to your computer, or when another

SCSI device is connected on a daisy chain and the scanner is the last SCSI

device on the end of the daisy chain>

Set the terminator switch to ON.

In such a connection, be sure to set the terminator on all other SCSI devices to

OFF.

Terminator OFF

Terminator ON

<When another SCSI device is connected as the last device of the daisy

chain>

Set the terminator switch on the scanner to OFF.

In such a connection, set the terminator on the SCSI device connected as the end

device to ON.

Terminator ON, or

attach terminator.

Terminator OFF

Be sure to set the DIP switch or use a terminator plug if this scanner is installed as the

last piece of equipment in a daisy chain. Note that if you use a terminator plug and the

DIP switch is set to ON, the scanner may malfunction.

2.2 Connecting to a Computer

Important

CAUTION

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 109 110

Sin comentarios

Canon 9080C - DR - Document Scanner Manual de instrucciones Pagina 25