Canon imagePROGRAF W8400D El manual del propietario descargar pdf

Moving the Printer

Follow this procedure before moving the printer to protect the internal parts

during moving or shipping.

• If you cannot avoid tilting or standing the printer on end when you are

moving it, please contact the dealer where you purchased the printer

or the nearest service center.

• Before you move the printer, always execute the Move Printer menu

function and follow the directions given by the messages on the

display. The printer may be damaged if you attempt to move it after

disconnecting the power cord before switching off the printer. If you

accidentally disconnect the power cord before switching the printer off,

reattach the power cord, reinstall the ink tanks, then start the

procedure again from Step 1.

• You cannot execute Move Printer once the MTCart Full Soon or

Replace MT-Cart appears. Replace the maintenance cartridge before

executing Move Printer.

• Never tilt the printer while you are moving it. This could spill ink from

the maintenance cartridge and cause ink stains in the surrounding

area.

1 If the printer power is off, press the Power button to switch the printer

on.

After a few moments, Online appears in the display.

1 2 3 4 5 6

Moving the Printer Follow this procedure before moving the printer to protect the internal parts during moving or shipping. • If you cannot avoid

2 Press the Online button to display MAIN MENU. 3 Press [ ] or [ ] to select Maintenance, then press [ ]. 4 Press [ ] or [ ] to select Move P

7 Open the ink tank cover, then remove all the ink tanks. Place each ink tank in a plastic bag and seal the bag. Store the removed tanks with the

10 Open the top cover, and then open the paper tray. Do not touch any areas other than as indicated. Doing so may damage the printer. 11Rewind the

13 Clamp the belt with the belt stopper then use the hex screws to fasten the belt stopper. Attach the belt stopper that you removed and stored dur

16 Tape each printer cover in the reverse order of tape removal during setup. 17 To remove the stacker, apply the attachment procedure in reverse.

Sin comentarios

Canon imagePROGRAF W8400D El manual del propietario