Canon PowerShot S80 User Guide Advanced Manual de usuario descargar pdf (Pagina 77)

Photobooth Shooting 77

Next identify the correct COM port for the serial port. This can be done by using a small piece of wire

and connecting pins 1 and 4 on the DB9 connector (shown below). If the correct COM port is selected

the "Pin 1" checkbox in the Photobooth Pushbutton utility should be checked when pins 1 and 4 are

connected. If nothing happens try selecting a different COM port from the drop down list.

Now wire up the button or buttons to the appropriate pins on the DB9 socket e.g. if you're using two

buttons pin 4 should be connected to the "common" connections of the two buttons and pin 1 should

be connected to the "push to make" connection of one button and pin 6 to the "push to make"

connection of the other button. Normally the connections would be made by soldering the wires to the

DB9 connector but if you're not happy with soldering you can use an RS-232 cable instead and simply

cut off one end, identify which wires to use and then connect them to the spade connections on the

buttons using crimp connectors.

Once the buttons are connected they can be tested by observing whether the appropriate checkboxes

are checked in the pushbutton utility app when each button is pressed.

Finally, select the required action for each button using the drop down lists in the pushbutton utility e.g.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 105 106

Sin comentarios

Canon PowerShot S80 User Guide Advanced Manual de usuario Pagina 77