
Envelope Feeder Attachment-B1
7-17
7-177-17
7-17
7
77
7
Handling Options
•
••
•
The main unit and the Envelope Feeder Attachment are set so that COM10 envelopes can be
loaded without any adjustment. The guide sizes can be changed so that the following envelopes
can be loaded. Using envelopes other than these can result in paper jams, dirty prints, and the
inside of the machine becoming dirty.
- COM10: Mailwell No.553
- Monarch: Mailwell No.582
- DL: Mailwell/Schneidersöne No.11345
- Yougata 4: Uzumaki Y-401
•
••
•
If you wish to use ISO-C5 or ISO-B5 envelopes, contact your service representative.
NOTE
•
••
•
To use envelopes other than COM10, refer to ‘Adjusting the Envelope Feeder Attachment to Hold a
Different Type of Envelope,’ on p. 7-23.
•
••
•
Only the upper most cassette can be used as the envelope cassette.
•
••
•
The allowable envelope sizes are as follows:
- COM 10: 104.7 x 241.3 mm
- Monarch: 98.4 x 190.5 mm
- DL: 110 x 220 mm
- ISO-C5: 162 x 229 mm
- ISO-B5: 176 x 250 mm
- Yougata 4: 105 x 235 mm
Before Loading the Envelopes
Before Loading the EnvelopesBefore Loading the Envelopes
Before Loading the Envelopes
This section explains what you should do before loading envelopes into the drawer.
1
11
1
Take five or so envelopes, and loosen them as shown. Then stack them
Take five or so envelopes, and loosen them as shown. Then stack them Take five or so envelopes, and loosen them as shown. Then stack them
Take five or so envelopes, and loosen them as shown. Then stack them
together.
together.together.
together.
Repeat this step five times.
Downloaded from ManualsPrinter.com Manuals
Comentarios a estos manuales