
Making Prints Using the Stack Bypass
1-47
1-471-47
1-47
Before You Start Using This Machine
1
11
1
Making Prints Using the Stack Bypass
Making Prints Using the Stack BypassMaking Prints Using the Stack Bypass
Making Prints Using the Stack Bypass
When making prints on transparencies, or non-standard size paper stock, load the paper stock
in the stack bypass.
IMPORTANT
•
••
•
Note the following points when using the stack bypass:
- Copy quantity: 1 to about 50 sheets (stack about 5 mm high)
- Paper size: 100 mm x 139 mm to 297 mm x 432 mm
- Paper weight: 64 g/m
2
to 128 g/m
2
- Curl down paper before use. (Curl amount: less than 10 mm for normal paper; less than 5 mm for
heavy paper) There are some types of paper stock which may meet the above specifications but
cannot be fed in the stack bypass.
•
••
•
Do not load different size/type paper at the same time.
•
••
•
A4-size tracing paper must be placed vertically in the stack bypass. Placing this paper horizontally
may cause creases on the print, depending on the moisture absorption condition of the paper.
•
••
•
A4-size transparencies must be placed vertically in the stack bypass. Placing this paper horizontally
may cause blurred images.
•
••
•
When making two-sided prints, select the Two-sided mode. Not selecting the correct mode may,
cause creases on the print, depending on the moisture absorption condition of the paper.
•
••
•
To print on the rear side of printed paper, it is recommended you load the paper in one of the paper
drawers.
•
••
•
When printing on envelopes, empty the output tray when at most 10 printed envelopes accumulate
in the tray.
•
••
•
When you select “Free Size” for copying, you cannot use the Auto Zoom, Entire Image, Finisher,
Hole Punch, 1 2-Sided, 2 2-Sided, Book 2-Sided, Two-page Separation, Cover/Sheet
Insertion, Shift (Centre/Corner), Booklet, Transparency Interleaving, Image Combination, Image
Separation, or Image Repeat modes.
•
••
•
When you select “Free Size” for printing documents stored in the mail box, you cannot use the
Finisher, 2-Sided, Document Contiguous/Separate Duplex Printing, Cover/Sheet Insertion, or
Booklet modes.
NOTE
•
••
•
When scanning the following originals, you cannot use Automatic Paper Selection. Use Manual
Paper Selection with these types.
- Highly transparent originals such as transparencies
- Originals with an extremely dark background
n Standard Size
Standard SizeStandard Size
Standard Size
You can select standard inch paper, or A or B series paper.
n Free Size
Free SizeFree Size
Free Size
You can place non-standard size paper (100 mm x 139 mm to 297 mm x 432 mm).
Downloaded from ManualsPrinter.com Manuals
Comentarios a estos manuales