
39
Error Messages
Error Message Cause Corrective Action
Execute printhead cleaning. The Printhead nozzles are
clogged.
Follow these steps to clean the Printhead .
If this message is still displayed, replace the
Printhead .
Cannot adjust printhead. The Printhead nozzles are
clogged.
Execute Head Posi. Adj. again, as follows.
Press the OK button to clear the error.1.
Print a test pattern to check the nozzles.2.
Clean the Printhead if the nozzles are clogged.3.
Execute Head Posi. Adj. again.4.
The Printhead cannot be aligned;
highly transparent film is loaded.
Press the OK button to clear the error.
(→"Checking for Nozzle Clogging," User Manual)
(→
, If Vertical Lines are Warped or Colors are
Misaligned)
(→ , If Printing is Faint)
(→ , If Vertical Lines are Warped or Colors are
Misaligned)
The Printhead is installed crooked. Straighten the Printhead as follows, and then execute
Head Posi. Adj. again.
Use Head Inc. Adj. to adjust the angle of inclination
of the Printhead .
2.
Execute Head Posi. Adj. again.3.
(→"Adjusting Line Misalignment (Head Inc. Adj.),"
User Manual)
(→ , If Vertical Lines are Warped or Colors are
Misaligned)
We recommend using a type of paper that you often
use, other than film, for Printhead adjustment.
Press the OK button to clear the error.1.
Stop printing by pressing ▲ or ▼ to select Stop
Printing .
Clean the Printhead .2.
1.
(→
, If Printing is Faint)
(→
, Replacing the Printhead)
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing. However, note that this
error may affect the printing quality.
If OK is shown on the Display Screen , clean the
Printhead .
If this message is still displayed, replace the
Printhead .
Clean the Printhead .2.
(→
, If Printing is Faint)
(→
, Replacing the Printhead)
Press the OK button on the Control Panel to stop
printing.
1.
Comentarios a estos manuales