Canon imagePROGRAF W2200S Manual de usuario descargar pdf (Pagina 19)

Setting the Printer IP Address

2-3

Important

Setting the Printer IP Address

Before setting the printer protocol, you must set the IP address to enable

communication between the printer and the computer. You can use one of the

methods below to set the IP address. Use whichever method is easiest:

• GARO Device Setup Utility (Æ P.2-4)

• ARP/PING command (Æ P. 2-6)

• Printer operation panel (Æ P. 2 - 7 )

z When you use the GARO Device Setup Utility to perform the printer network

settings, the subnet mask and gateway address settings are set to 0.0.0.0, so use the

Remote UI or printer operation panel to make the settings for your network.

z If you are using an operating system that is not compatible with the GARO Device

Setup Utility, use another computer on the network, use the ARP/PING command,

or use the printer operation panel to perform the settings.

z The GARO Device Setup Utility must be installed on your computer in order to

use this utility to make the settings. Ask your system administrator to install the

GARO Device Setup Utility on your computer. (Æ Setup Guide)

z Before setting the IP address, confirm that the printer is switched on and connected

to the network.

z The MAC address is required to perform the setting with the GARO Device Setup

Utility or the ARP/PING command. If you need to confirm the MAC address, use

the printer operation panel to print a Status Print or Ext. I/F Print.

1. Press the Online button. The Online lamp switches off.

2. Press the Cancel Job/Utility button.

3. Press  or  to select Status Print or Ext. I/F Print then press .

z Before setting the IP address, confirm that the printer is switched on and connected

to the network.

z If you are using a DHCP, BOOTP, or RARP server where the IP address is

acquired automatically, use the printer operation panel to select “Automatic” for

the “IP Mode” setting, then select ON for the server in use.

z If you are using a DHCP, BOOTP, or RARP server, selecting the IP address for the

printer is not required. However, the IP address changes every time the printer is

powered on, so in order to access the printer every time the printer is switched on,

the IP address must be checked by Status Print or Ext. I/F Print.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 106 107

Sin comentarios

Canon imagePROGRAF W2200S Manual de usuario Pagina 19