Canon CanoScan 8000F Manual de usuario

1EnglishQuick Start GuideQuick Start GuideSetup and ScanningTry the Additional FeaturesCheck the Package ContentsInstall the SoftwareWindowsMacintoshU

10Try Scanning 7Click [Scan].The final scan will start. 8Click or (close box) in the ScanGear CS window to close it.The scanned image will appear

11Using the Scanner ButtonsYou can use the four convenient buttons on the front of the scanner to scan and perform related tasks easily with a single

12Scanning FilmYou can scan 35 mm film (film strips or slides) with this scanner.Positioning the Film Use the following procedures to insert the film

13Scanning Film3Place the loaded film guide on the scanner platen.Align the tab on the side of the film guide with the FILM mark on the platen. 4Close

14Scanning Film 3In the [Select source] category, select [Film].4In the [Film type] category, select [Nega/Sleeve] or [Posi/Sleeve].3Select the film t

15Scanning Film5Click [Preview].6Place a check mark beside the number(s) of the frame(s) to be scanned and click [Scan].At first, a check mark only ap

16Specifications*1 Available only when scanning films.*2 USB 2.0 Hi-Speed mode. Transfer time to computer is not included.*3 Calibration processing ti

17System InformationThis form should be used to record the operating environment for the purchased scanner. If any problems occur with the scanner, yo

2Guide to the Manuals• CanoScan and ScanGear are trademarks of Canon Inc.• Adobe®, Acrobat® and Photoshop® are trademarks of Adobe Systems Incorporate

3Check the Package ContentsScanner and AccessoriesDocuments and Software Programs• Quick Start Guide (this guide)• Additional Documents• CanoScan Setu

4Install the Software (Windows)1Turn the computer on.2Place the CanoScan Setup Utility CD-ROM in the drive.After you select your language, the CanoSca

5Install the Software (Macintosh)1Turn the computer on. 2Place the CanoScan Setup Utility CD-ROM in the drive.After you select your language, the Cano

6Unlock the Scanning Unit1Peel the seals from the scanner.2Gently turn the scanner over.3Push the lock switch toward the unlock mark ( ). 4Return the

7Connect the Scanner1Peel the caution seal from the back of the scanner.2Connect the FAU cable to the scanner.3Connect the scanner to the computer wit

8Try Scanning The following steps explain how to scan with ArcSoft PhotoStudio.1Place a photo or a picture on the glass by aligning its top edge with

93Click the Acquire icon or click the [File] menu and select [Acquire].ScanGear CS will start.If an error message appears, click the [File] menu, ch